MUFF WIGGLER Forum Index
 FAQ & Terms of UseFAQ & Terms Of Use   Wiggler RadioMW Radio   Muff Wiggler TwitterTwitter   Support the site @ PatreonPatreon 
 SearchSearch   RegisterSign up   Log inLog in 
WIGGLING 'LITE' IN GUEST MODE

iProgram card display problem
MUFF WIGGLER Forum Index -> Buchla, EMS & Serge  
Author iProgram card display problem
ritchiedrums
Asking here hoping someone had a similar problem

I have not used the iProgram card in about a year.
It has been sitting.
Now the display goes dark after a few minutes.
It is working perfectly, but the display won't stay on.
If it is powered back on it lights again for a few minutes.......
rolsteins
ritchiedrums wrote:
Asking here hoping someone had a similar problem

I have not used the iProgram card in about a year.
It has been sitting.
Now the display goes dark after a few minutes.
It is working perfectly, but the display won't stay on.
If it is powered back on it lights again for a few minutes.......


I's strange. Maybe it has some kind of dirt on connectors? Or loose connectors? Also I have not used this card for almost year - I was haunted by this feeling that with iProgram card easel sounds different (and not better) form how it sounds with real wire connectors.
Drillionaire
What do you have other than the 208 in your case? If it's something other than a 218, the power board might be going into thermal overload protection because it's trying to supply too much current.
ritchiedrums
Drillionaire wrote:
What do you have other than the 208 in your case? If it's something other than a 218, the power board might be going into thermal overload protection because it's trying to supply too much current.


MAKES SENSE!
I will look into this over the weekend
Guinness ftw!
ritchiedrums
MAYBE I DO HAVE TOO MUCH NOW Mr. Green

MUFF WIGGLER Forum Index -> Buchla, EMS & Serge  
Page 1 of 1
Powered by phpBB © phpBB Group