MUFF WIGGLER Forum Index
 FAQ & Terms of UseFAQ & Terms Of Use   Wiggler RadioMW Radio   Muff Wiggler TwitterTwitter   Support the site @ PatreonPatreon 
 SearchSearch   RegisterSign up   Log inLog in 
WIGGLING 'LITE' IN GUEST MODE

control guitar pedal with 1010 euroshield 1?
MUFF WIGGLER Forum Index -> Guitars, Basses, Amps & FX  
Author control guitar pedal with 1010 euroshield 1?
davebot1
Hi there, sorry for the poorly thought out post.

It struck me that it might be possible to use the 1010 Music euroshield 1 to control a guitar pedal.

The pots on a pedal are just attenuators, right? Could you (1) measure the voltage drop while wiggling the pot to get the end points and maybe some extra points to get the curve of the voltage change, then (2) write a small program that takes in a CV signal and outputs some voltage to control a voltage-controlled-attenuator?
Then the pedal audio ins-and-outs would be mounted next to the sheild.

Seems like it would be a shortcut towards incorporating CV into pedals.

Just a thought.
MUFF WIGGLER Forum Index -> Guitars, Basses, Amps & FX  
Page 1 of 1
Powered by phpBB © phpBB Group