Connecting Mother-32 to Behr Neutron

Any music gear discussions that don't fit into one of the other forums.

Moderators: Kent, Joe., analogdigital, infradead, lisa, parasitk, plord

Post Reply
Man-In-A-Suitcase
Wiggling with Experience
Posts: 345
Joined: Sun May 18, 2014 10:57 am
Location: SPECTRE HQ

Connecting Mother-32 to Behr Neutron

Post by Man-In-A-Suitcase » Mon Aug 05, 2019 9:58 am

I want to sequence a Behr Neutron from my Mother-32, what do i need to patch out from M-32 to the Neutron in.

Note: Not sure if i had to post this in here or the Eurorack section ?

User avatar
bwhittington
Terrifying Brain Secret
Posts: 5709
Joined: Thu May 21, 2009 11:48 pm

Post by bwhittington » Mon Aug 05, 2019 10:50 am

Patch the Mother KB Out to the Neutron VCO 1+2 in for pitch. Patch the Mother Gate Out to the Neutron EG 1 or 2 for the gate. (I suppose you might want to use the Mother's mult to send the signal to both EG's? Don't know if they are normalled.)

Also, the Assign Out on the Mother is set as sequencer accent by default. Might be useful to patch that to the Neutron as well. VCF freq mod, res, amplitude if that is somewhere. Don't know the Neutron, really.

Post Reply

Return to “General Gear”