MUFF WIGGLER Forum Index
 FAQ & Terms of UseFAQ & Terms Of Use   Wiggler RadioMW Radio   Muff Wiggler TwitterTwitter   Support the site @ PatreonPatreon 
 SearchSearch   RegisterSign up   Log inLog in 
WIGGLING 'LITE' IN GUEST MODE

Power Splitting Cable
MUFF WIGGLER Forum Index -> Fractional Rack Modules  
Author Power Splitting Cable
GCF
Hey folks,

So I have a couple modules on the way (VCS and LPFA), and I already have a rack full of Frac. I held off on buying the power board because I didn't think I would get more than 6 fracs for a while. But now I have more modules than there are built in spots.

Is it unsafe to build a power cable that splits from one spot to two modules? I know the voltages and everything should be fine, but I don't want to miss something and fry two new modules.

Thanks.

GCF
K9Mike
As long as your PS can handle the load, absolutely no problem at all making "Y" power cable splitters. Goes without saying to ensure you get the pinouts correct.
MUFF WIGGLER Forum Index -> Fractional Rack Modules  
Page 1 of 1
Powered by phpBB © phpBB Group