WIGGLING 'LITE' IN GUEST MODE

[snufkin]

hi guys i am thinking of getting two of the MMM Voltage Controlled Dual Low Frequency Oscillator boards to mount behind a euro panel

I see the hookup kits and the pots/jacks/switches on the mmm site but how about connectors for doepfer style power? is the 4-pin 0.156” MTA socket to 16 pin Euro the right one?


also can you guys give me advice on how small I can make a euro panel that has to house controls for two VLF1-B the system I want to build is really tight on space but I would like quite allot of power

thats 12 jacks 12 pots and 8 leds

is this a silly idea???

[mmm]

[negativspace]

You may be overstating things a bit there, George.

I'd say you could do it in 16hp if you're creative with your LED placement, or 18 if you want to give them a little space. (I routinely build VCFs with 6 knobs and 6 pots on 8hp panels, but they're pretty tight.) Might be a good idea to start your design at 18 or 20 and cut it down if you find that it can take it. As you increase your control density, always keep in mind that the parts are larger behind the panel than on it. There's only so far you can go.

And it's not a silly idea at all, MMM modules work out great in Euro. My Quad AD/ASR module is probably the single most-used module in my 18U.

[mmm]