MUFF WIGGLER Forum Index
 FAQ & Terms of UseFAQ & Terms Of Use   Wiggler RadioMW Radio   Muff Wiggler TwitterTwitter   Support the site @ PatreonPatreon 
 SearchSearch   RegisterSign up   Log inLog in 
WIGGLING 'LITE' IN GUEST MODE

Trouby Math Sequencer in Modcan A?
MUFF WIGGLER Forum Index -> Trouby Modular  
Author Trouby Math Sequencer in Modcan A?
SunSpots
Trouby,

I tried PMing you, but maybe it was lost.

I was wondering if you could do the same unit but with a Modcan A sized panel and bananna jacks? I have a huge box and I want to try to get your unit into the box. I don't mind paying a little more for the customization. I think all the wiring/electronics would be the same?
+/- 5V?

SunSpots
trouby
only +12 or +15V, 5V regulator on module.
GO or RESET signal?
SunSpots
Are you saying there's *no* 5V regulator on module, or there is?

And I'm not sure what you're asking about the GO/RESET signals? Are you talking about the gate on/off? I believe it's all +/- 5V in Modcan... correct me if I'm wrong.

I also mentioned this in the email, but a CV controllable jack to control the two math numbers would be awesome!

SunSpots
trouby
for sure there is a 5V regulator on module.
Gate and lot of CV is 0-5V.

GO (start/stop) & Reset are gates to start & stop the sequencer.
GO=1 (dotcom) or Reset=0 starts the sequencer.

banana jacks: black, blue, green, red are avail. - this 4 colors should be a jack row.
MUFF WIGGLER Forum Index -> Trouby Modular  
Page 1 of 1
Powered by phpBB © phpBB Group