Arp 2500 replacement buttons for 1050 Mix-Sequencer

From circuitbending to homebrew stompboxes & synths, keep the DIY spirit alive!

Moderators: Kent, Joe., analogdigital, infradead, lisa, parasitk, plord, sduck

Post Reply
David Baron
Learning to Wiggle
Posts: 15
Joined: Tue Apr 28, 2009 9:23 pm
Location: New York/Woodstock

Arp 2500 replacement buttons for 1050 Mix-Sequencer

Post by David Baron » Fri May 29, 2009 9:07 am

Does anyone know where I can obtain replacement buttons for the 1050? I'm missing a few of the numbers....

User avatar
Soy Sos
Dub Surgeon
Posts: 4489
Joined: Thu Apr 03, 2008 9:38 am
Location: Pittsburgh, PA USA

Post by Soy Sos » Fri May 29, 2009 9:35 am

Phil Cirocco is the guy to talk to.
http://www.discretesynthesizers.com/
If anyone in the states knows, it'd be him. He did some upgrades and repairs
on my 2600 years ago when he was in N.E. PA. He's move to Georgia.

User avatar
alt-mode
Wiggling with Experience
Posts: 337
Joined: Sat Feb 07, 2009 11:31 am
Location: Massachusetts

Post by alt-mode » Fri May 29, 2009 12:29 pm

AFAIK, you won't be able to find any with the numbers on them. I had to replace an "off" button on a 1027 sequencer before selling it and the tech could only find blank buttons.

You can try David White, analogkeys@aol.com for some of the blank buttons and perhaps can add a number decal on top.

Bob Williams of Analogue Systems also used to sell ARP 2500 knobs. I don't know if he has any buttons.

Eric

David Baron
Learning to Wiggle
Posts: 15
Joined: Tue Apr 28, 2009 9:23 pm
Location: New York/Woodstock

thank you

Post by David Baron » Sun May 31, 2009 7:33 pm

thank you!

User avatar
Morley
Super Deluxe Wiggler
Posts: 2935
Joined: Wed Oct 15, 2008 2:55 pm
Location: Belgium

Post by Morley » Sat Jun 20, 2009 4:12 am

alt-mode wrote:AFAIK, you won't be able to find any with the numbers on them. I had to replace an "off" button on a 1027 sequencer before selling it and the tech could only find blank buttons.

You can try David White, analogkeys@aol.com for some of the blank buttons and perhaps can add a number decal on top.

Bob Williams of Analogue Systems also used to sell ARP 2500 knobs. I don't know if he has any buttons.

Eric
I have 2 different versions of the 1027 btw. One has "ON" and "OFF" printed on the actual panel. The others have it on the knobs

Post Reply

Return to “Music Tech DIY”