Mididac setting up

Discussion and support for users and builders of Oakley Sound musical products.

Moderators: Kent, Synthbuilder

Post Reply
rarecomponent
Learning to Wiggle
Posts: 28
Joined: Wed Dec 21, 2011 7:56 am

Mididac setting up

Post by rarecomponent » Thu Apr 26, 2012 1:22 pm

Ive populated the Mididac board and double checked everything....

I want to pre-check for a GATE signal but have not connected the TUNE or BEND / DEPTH or SLIDE TIME pots or the two switches. At the moment the LED doesnt flash with Midi signal in on any channel.

Will the PCB Gate LED function without these connected?

Also I'm using a REF195GPZ:IC VOLT REF 5V in U3 which I'm not sure is correct

rarecomponent
Learning to Wiggle
Posts: 28
Joined: Wed Dec 21, 2011 7:56 am

Post by rarecomponent » Thu Apr 26, 2012 3:25 pm

problem solved....would you believe I had a dud LED ???!!!!!!

Midi in and gate signal is working fine.

Post Reply

Return to “Oakley Sound Systems”