909 kick resistors

Discussion for Hexinverter eurorack modules - email Hex if you need anything urgent!

Moderators: Kent, infradead, hexinverter

Post Reply
User avatar
ericD13
Wiggling with Experience
Posts: 455
Joined: Wed Apr 04, 2012 4:11 am
Location: France (near belgium)

909 kick resistors

Post by ericD13 » Thu May 16, 2013 12:28 pm

hello

I'm trying to build one of these beasts.

It seems there are inconsistencies
For now I've seen
R16 is 1.5 M on the board (in real and on photo on site) but is 333K on schematic and BOM
R10 is 330 K on the board (in real and on photo on site) but is 1.5Mon schematic and BOM

Same inversion for R3 and R4.

Do I have to follow the values on the board ?
"Unfortunately it took me forty years to conclude that nothing is possible outside DoReMi."
P. Schaeffer

Lots of 5U modules to sell in europe :
https://www.muffwiggler.com/forum/viewt ... p?t=219781

User avatar
hexinverter
the nettles make me think happy times
Posts: 2968
Joined: Thu Aug 25, 2011 8:48 pm
Location: Montreal, Canada

Re: 909 kick resistors

Post by hexinverter » Thu May 16, 2013 2:43 pm

ericD13 wrote:hello

I'm trying to build one of these beasts.

It seems there are inconsistencies
For now I've seen
R16 is 1.5 M on the board (in real and on photo on site) but is 333K on schematic and BOM
R10 is 330 K on the board (in real and on photo on site) but is 1.5Mon schematic and BOM

Same inversion for R3 and R4.

Do I have to follow the values on the board ?
Hey Eric!

This is probably just names getting swapped around in my PCB software -- ie: not being placed on top of the proper part's footprint. It happens sometimes just out of silly human error.

Please follow the component values silkscreened onto the board. They are correct :)
Hexinverter Électronique
em: stacy[at]hexinverter.net

Post Reply

Return to “Hexinverter Electronique”