Blacet I/O dipswitch?

Blacet, Metalbox, Synthasonic, PAiA and the rest.... a frac frenzy!

Moderators: Kent, luketeaford, lisa, Joe.

Post Reply
User avatar
tragedybysyntax
Banned until Restitution Made
Posts: 2913
Joined: Sat Jun 16, 2007 11:39 am

Blacet I/O dipswitch?

Post by tragedybysyntax » Mon Nov 16, 2009 9:31 am

Curious..... what should the dipswitch settings be for normal use? I've honestly never used the 1/4" jack until now and I"m not getting any signal in from a 1/4" source. Thanks guys!
Image
- [ Custom Metalwork ] -

Babaluma

Post by Babaluma » Mon Nov 16, 2009 9:45 am

depends on the impedance of what you plug in to it. try both, see which sounds best. you might get high end roll off etc. on guitars and things, and the other setting might sound clearer. i remember plugging a bass into my old one and switching the dip, and not noticing any difference in sound at all.

User avatar
parasitk
Learn to swim
Posts: 4939
Joined: Thu May 15, 2008 11:47 am
Location: Lost Angeles
Contact:

Post by parasitk » Mon Nov 16, 2009 9:48 am

One of them is for supplying voltage to the 1/4" jack – I have that on and use it to power my ribbon controller.

Here, everything you'd like to know:
http://www.blacet.com/IOmanualBasic.pdf

:party:

User avatar
tragedybysyntax
Banned until Restitution Made
Posts: 2913
Joined: Sat Jun 16, 2007 11:39 am

Post by tragedybysyntax » Mon Nov 16, 2009 2:43 pm

Ahh! thanks guys. I had that pdf but I didnt see it had the writing on the PCB for what each switch did. SWEET! 1/4" jack works now.... lol.
Image
- [ Custom Metalwork ] -

Post Reply

Return to “Fractional Rack Modules”